SINO has very mature experience with multi cavity thin wall IML container molds.

The4 cavity of 1 literthin wall containermold we can make now is only 0.4mm thickness, cycle time around 5-6seconds.Annually, we make over 300 setsthin wall container molds.

Thetechnology of the thinwall injection mold is important during the moldingprocess, we choice the correct steel to ensure the dimension(usually it is S136from ASSAB)based the problem to adopt right measurement.

1.Thinwallhigh speed injection mold supplier: SINO-MOULD

2.Hotterrunner suppler: Anole Hot Runner

3.Robotsuppler: DKM robot system combine with Italy technology.

MainChinese thinwall injection mold technology problem and solution:

1.Airsystem design: Trapped gas, burns and short shot due to the thinwall forming oflarge area. During design, we need to make mold flow analyse.

2.Controlof the deformation: hard ejection of the forming because of the complex of themold structure. When design ejector ,we need to pay more attention about thispoint and try to avoid the problem.

3.Guaranteeof the mold hardness: assure the mold overall compression based on thestructure and material used. As a famous supplier, we usually use S136 fromASSAB.

4.Researchof the thinwall forming technical: thinwall products' flow channel is narrowerthan the traditional's ,easier cooling during the forming process, this is thekey point. We usual optimization molding process parameters,make reasonablemolding process to ensure the technology specification

Snow

Export3@cnmould.com